Development of certified reference material of mineral composition of natural water designed to control of turbidity measurement accuracy

Introduction. The results of development of a certified reference material (CRM) of mineral composition of natural water are presented. A solution prepared from the material of the CRM specimen imitates mineral composition of natural surface water. The certified values are mass fractions of nitrate ions, chloride ions, fluoride ions, and total iron and turbidity according to formazine scale. Materials and methods. The certified values of mass concentrations of the components were determined using calculated experimental evaluation procedure;the certified turbidity value was determinedusing the certified turbidimetric method. Results. The relative expanded uncertainty (k = 2) of the certified turbidity values does not exceed 5 %, the same value for mass concentrationsis not more than 3.5 %. Relative standard uncertainty from heterogeneity does not exceed 1.0 %. The shelf life of the developed CRM is set to 3 years. Discussion and conclusion. Developed CRM was registered in the State Register of CRM's as GSO 10815-2016. The CRM is designed to control the accuracy of results of the certified characteristics measurements, including proficiency testing of laboratories using interlaboratory comparative tests. The CRM can be used for validation of measurement procedures.

мутность, нитрат, фторид, хлорид, общее железо, вода природная, формазин, турбидиметрия, стандартный образец, turbidity, nitrate, fluoride, chloride, total iron, natural water, formazine, turbidimetry, certified reference material

1. ГОСТ ИСО/МЭК 17025-2009 Общие требования к компетентности испытательных и калибровочных лабораторий. М.: Стандартинформ, 2012. 29 с.

2. The rapid determination of albumin in urine / F.B. Kingsbury [et al.] // Journal of Laboratory and Clinical Medicine. 1926. No. 11. Pp. 981-989.

3. ISO 7027-1:2016 Water quality - Determination of turbidity - Part 1: Qualitative methods. 9 p.

4. U.S. EPA Method 180.1 Determination of turbidity by nephelometry. Washington, D.C., EPA. 1993. 10 p.

5. ГОСТ 3351-74 Вода питьевая. Методы определения вкуса, запаха, цветности и мутности. М.: ИПК Издательство стандартов, 2003. С. 321-328.

6. ГОСТ Р 57164-2016 Вода питьевая. Методы определения запаха, вкуса и мутности. М.: Стандартинформ, 2016. 23 с.

7. СанПиН 2.1.4.1074-01 Питьевая вода. Гигиенические требования к качеству воды централизованных систем питьевого водоснабжения. Контроль качества. М.: Информационно-издательский центр Минздрава России, 2002. 62 c.

8. ГОСТ 2761-84 Источники централизованного хозяйственно-питьевого водоснабжения. Гигиенические, технические требования и правила выбора. М.: Стандартинформ, 2006. 12 с.

9. РМГ 93-2009 Государственная система обеспечения единства измерений. Оценивание метрологических характеристик стандартных образцов. М.: Стандартинформ, 2011. 28 с.

10. МИ 1992-98 Рекомендация. Государственная система обеспечения единства измерений. Метрологическая аттестация стандартных образцов состава веществ и материалов по процедуре приготовления. Основные положения. Екатеринбург: УНИИМ, 1998. 11 с.

11. ПНД Ф 14.1:2:4.213-05 Количественный химический анализ вод. Методика выполнения измерений мутности питьевых, природных и сточных вод турбидиметрическим методом по каолину и по формазину. М.: ФГУ «Федеральный центр анализа и оценки техногенного воздействия», 2005. 14 с.

12. ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories. Moscow, Standartinform Publ., 2012. 29 p. (In Russ.)

13. Kingsbury F.B., Clark C.P., Williams C., Post A.L. The rapid determination of albumin in urine. Journal of Laboratory and Clinical Medicine,1926, 11, pp. 981-989.

14. ISO 7027-1:2016 Water quality - Determination of turbidity - Part 1: Qualitative methods. 9 p.

15. U.S. EPA Method 180.1 Determination of turbidity by nephelometry. Washington, D.C., EPA. 1993. 10 p.

16. State Standard 3351-74 Drinking water. Methods for determining the taste, odor, color and turbidity. Moscow, PPC Izdatel'stvo Standartov, 2003. Pp. 321-328. (In Russ.).

17. State Standard 3351-74 Drinking water. Methods for determining the odor, taste and turbidity. Moscow, Standartinform Publ., 2016. 23 p. (In Russ.)

18. Sanitary Rulesand Norms 2.1.4.1074-01 Potablewater. Hygienic requirements for water quality in central potable water supply systems. Quality control. Moscow, Informatsionno-izdatel'skij centr Minzdrava Rossii, 2002. 62 p. (In Russ.)

19. State Standard 2761-84 Sources of centralized household and drinking water supply. Hygienic, technical requirements and selection rules. Moscow, Standartinform Publ., 2006. 12 p. (In Russ.)

20. Recommendations on interstate standardization 93-2009 State system for ensuring the uniformity of measurements. Estimation of metrological characteristics of reference materials. Moscow, Standartinform Publ., 2011. 28 p. (In Russ.)

21. Methodical instruction 1992-98 Recommendation. State system for ensuring the uniformity of measurements. Metrological certification of reference materials of substances and materials according to the preparation procedure. Main principles. Ekaterinburg: UNIIM Publ., 1998. 11 p. (In Russ.)

22. Federal Environmental regulations 14.1:2:4.213-05 Quantitati vechemical analysis of water. Method for measuring the turbidity of drinking water, natural water and sewage water using kaoline and formazineturbidimetric methods. Moscow, FCAA, 2005. 16 p. (In Russ.)